Development code

This forum is used for discussing hardware, software, and technical details of the AVRcam embedded system.

Development code

Postby Guest » Tue Jul 05, 2005 8:37 am

Hi,

Just woundering if you would posibly share your code during the development phase of the AVR Cam, by this i mean initial register set-up and capturing a frame with no processing etc etc. Building up to version 1. Just a thought.

Andy
Guest
 

Postby Guest » Wed Jul 06, 2005 6:45 am

Hi Andy,
Much of the "development" code I used to get the AVRcam up and running was left in the software base but #ifdef'ed out of the final build. Thus, you should be able to see what sorts of things I was doing to debug, and figure out how to adapt them to get new additions to the code up and running. All initial register setup is still in the code since it is needed in the released version of the software too.

Good luck...
Guest
 


Return to AVRcam Embedded System

Who is online

Users browsing this forum: No registered users and 13 guests

cron